The Social Network for Professional Concrete Artisans.
-
Brian Krompack
- Male
- Fishers, Indiana
- United States
- Share
- Blog Posts
- Discussions (132)
- Events
- Groups (1)
- Photos (5)
- Photo Albums
- Videos
Brian Krompack's Discussions
Da'Shaft
Latest Activity
I did it once. I wnt double what nipon does since the lower solids content. Worked fine sub out the water
Nice Brock
Ill be there. How far it the new place from the old place?
ditto
Was that some kind of shot at me OJ?
Dont you have a queen in canada? Your political voice in the USA is mute. If you wont post in other forums out of fear then pull out and dont lurk. The idea of your ideas getting squashed is bad it could be for several reasons that I wont mention ...
Profile Information
- Membership requires that you enter your real First and Last name.
- Brian Krompack
Brian Krompack's Photos
Brian Krompack's Videos
-
Da'Shaft and Jim Ralston
Added by Brian Krompack
-
Da'Shaft, The real deal
Added by Brian Krompack
Comment Wall (14 comments)
- At 10:47pm on June 19, 2009,
Jimmy Archambault said… - brian where can i buy the shaft
- At 7:09pm on April 12, 2009,
Trueform Concrete said… - Hi Brian - That piece that you asked about was 1.5" thick. We make our own edges.
- At 6:18pm on February 14, 2009,
Cheryl Bandstra said… - Hi Brian - cold & snow is back! Boom showed me this site so am just getting familair with it!
- At 10:14am on February 9, 2009,
Allie Turley said… - Brian, It was crazy! We need to get with you and fill you in.....
- At 12:49am on February 9, 2009,
Cody Carpenter ------------aci said… - Thanks glad you like some of my work.
- At 8:53am on January 25, 2009,
Mike Cook said… - Leaving for the shop in a few. give me a call.
- At 6:33pm on January 18, 2009,
Tommy, Absolute ConcreteWorks said… - Hey Bro, Did you get your money yet? I still have yet to use it, but am looking forward to it. Later
- At 10:51am on December 28, 2008,
dreamindiesel said…
- Hi, I am learning the Decorative overlays, garage coatings, and am interested in learning how to do countertops.
Thanks
- At 8:18pm on November 20, 2008,
Mike Cook said…
- ok hopfully this pic comes out.
- At 3:12pm on October 20, 2008,
david wynn said… - Hey Brian, was going to post this question, but tell me what you think: Lately some of the slabs I've been wet casting has not turned out like my sample. Tried to keep my ratios consistent and all, but I'm getting a lot of crumbly corners. I wait for 4 days before I unmold, but the corners are breaking off when I grind.
I use basic Quickrete sacks, BORG acrylic admix, and I keep the admix ratio pretty high (>50% volume). My mix is runny oatmeal consistency, in fact, when I level out the mold, there is a bit of water that comes to the top. Am I just not waiting long enough to work it? Thanks.
© 2009 Created by Dave McVey
